© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
6.5. Beam Preset Type View
To go to the Beam Preset Type View, tap Beam in the Preset Type Bar.
- or -
Press and hold and press 5 , for preset type 5 (= Beam).
The beam preset type view is only active if the selected fixture has a beam attributes.
The beam preset type view is fragmented in the Shutter/Strobe/Iris View, the Prisma 1 View and the Raw Beam
Views (depending on the fixture types).
Important:
The beam sliders works absolute. A tap on a beam slider sets a new beam value and does not follow
the already set beam values.
The respective encoders works relative to the already set beam values.
To open the beam effects view at screen 1, tap at in the title bar.
If an effect is running on a selected fixture, the beam preset type view change into an effect mode and get a blue
effect mode title bar.
Shutter/Strobe/Iris View
The Sutter/Strobe/Iris View is the first tab of the beam preset type view.
To Next Page
Loading...
