MA lighting dot2 - Macro Command

To Next Page

To Previous Page

Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com

7.37. Macro Command

This page describes the syntax and how to use the marco command.

To go to the macro command, press Macro on the console.

Description

With the macro command, you start a macro from the macro pool.

Syntax

Start a macro.

Macro 1

Example

Let´s assume, you will start macro 1 (e.g. +5 %) to the selected fixtures.

Press Macro 1 Please .

Macro 1 is started.

Other manuals for MA lighting dot2