© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.6. At Command
This page describes the syntax and how to use the At command.
To go to the At command, press the At key on the console.
At is in the command line, now.
At
Description
With the At command, you can
apply values to selected fixtures
apply presets to selected fixtures
apply a value from a fixture to another fixture
apply a value to an executor
use it as a helping command for e.g. a copy function
Syntax
1. Apply values to the selected fixtures:
At 50
2. Apply presets to selected fixtures:
At Preset 1.2
3. Apply a value from a fixture to another fixture:
Fixture 1 At Fixture 2
4. Apply a value to an executor.
Executor 1 At 50
5. Use the At command as a helping command for a e.g. a copy function.
Copy Cue 2 At 3
To Next Page
Loading...
