© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
Example 1
Let´s assume, you will apply the dimmer value to 50 % to the selected fixtures.
At 5 0 Please
All selected fixtures have the dimmer value 50.
Double check the dimmer value in the Fixtures Sheet View.
If the master fader is not set to 100 %, the values in the Fixture Symbol View are smaller than in the
Fixture Sheet View.
Example 2
Let´s assume, you will apply a dimmer preset object to all selected fixtures.
1. Go to the Preset Pool Dimmer.
2. Tap a dimmer preset object.
OR
At Preset 1 . 2 Please
All selected fixtures have the selected dimmer preset objects.
Example 3
Let´s assume, you will apply the values from fixture 1 to fixture 2.
Select at first the fixture which should get the value and then the fixture where the value comes from.
1. Select the fixture which should get the value
Fixture 2
2. Select the fixture where the value comes from.
At Fixture 1 Please
Fixture 2 has the value from fixture 1.
Example 4
Let´s assume, you will apply the executor 3 to the value 50 %.
To Next Page
Loading...
