© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
7.71. Zero Command
This page describes the syntax and how to use the zero command.
Important:
If you type the Zero command in the console, by double press the . key, the command will be directly
executed.
You can also use the command line along with the virtual keyboard and type the word zero in.
To go to the zero command double press the . key on the console.
The command will be directly executed.
Description
With the zero command you can set the intensity to zero:
of the current selected fixtures
of a selection of fixtures
from an executor
Syntax
1. Set the intensity from the current selected fixtures to zero.
Zero
2. Set the intensity of a selection of fixtures to zero.
Fixture 1 Thru 3 Zero
3. Set the intensity from an executor to zero.
Executor 1 Zero
Example 1
Let´s assume you will set the intensity of all selected fixtures to zero.
Figure 1: Dimmer at 100 %
To Next Page
Loading...
