© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
Figure 2: Dimmer at 0%
Press . . .
The zero command will be directly executed.
The values of the selected fixtures are zero.
Hint:
Double-check the executed command in the command line view.
Example 2
Let´s assume you will set the intensity of the fixtures 1 thru 3 to zero.
Important:
Make sure, that no fixtures are selected. If fixtures are selected, the zero command will be always
execute to all selected fixtures.
Press Fixture 1 Thru 3 . . .
The Zero command will be directly executed.
The values of the fixtures 1 thru 3 are zero.
Example 3
Let´s assume you will set the intensity of the fixtures from the executor 1 to zero.
Important:
The physical fader doesn´t move.
Press Exec 1 . . .
The values from the fixtures of the executor 1 are set to zero.
To Next Page
Loading...
