© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
Example 1
Important:
If the DMX tester is on, all parked values and values from the programmer will be blocked by the dmx
test value.
To turn off the DMX tester, refer to example 2 or open the tools window.
Let´s assume you will make a DMX test with the DMX address 1.7 and set the DMX value at 100 %.
Press DMX 1 . 7 At 1 0 0 Please .
The DMX value is 254 and is displayed with a red background in the DMX View.
Example 2
Let´s assume you will turn off all DMX tester values by using the DMX command.
Press Off DMX Thru Please .
All DMX tester values are off.
Hint:
You can also use the tools window to turn off the DMX tester.
Example 3
Let´s assume, you will figure out which fixture is patched at DMX address 2.2.
Press DMX 2 . 2 Please .
The fixture patched at DMX address 2.2 is selected.
Hint:
If you are looking for a fixture patched at universe 1, just press DMX 2 Please . The universe is not
necessary for universe 1.
Example 4
Let´s assume you will patch fixture 1 to a the DMX address 2.1.
Press + Label (= Assign) Fixture 1 At DMX 2 . 1 Please .
Fixture 1 is patched at DMX address 2.1.
To Next Page
Loading...
