© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
A different option when we store is Cue Only. If we use that option and store fixture 1 at 40% in cue 5 you’ll see
that we didn’t make a change in cue 6. meaning it still looks the same as it did before we stored cue 5.
Cue
number
Fixture 1
Dim
1 50
2 50
3 60
4 60
5 40
6 60
If you add a fixture that hadn't previously been used, then the dot2 can automatically create a hidden cue
number zero and put the default value (the value a fixture has if it isn't told anything) in that cue. Cue Zero can be
activated in the Settings view for a cue list.
You can't access this cue, but it makes sure that cues look correct if you copy them.
Have a look at this example:
Cue
number
Fixture 1
Dim
1 0
2 50
3 50
4 50
5 50
6 50
Here we have fixture 1 that has a stored values in cue number 2. This value tracks from this cue and to cue 6. If
you copy cue number 1 to a new cue 3.5 using cue only, then you’ll see that the fixture has 0% in the new cue and
goes back to 50% in cue 4 - so cue number 4 has never changed.
Cue
number
Fixture 1
Dim
1 0
2 50
3 50
3.5 0
4 50
5 50
To Next Page
Loading...
