a) Press Edit Exec 1 Please .
b) Press Edit and then the respective executor button .
The cues view of executor 1 is visible at screen 1.
For this function, you can also use the view key / view command.
Example 2
Let´s assume, you will edit cue 2 on executor 1.
Press Edit 2 (= Cue 2) Exec 1 Please .
The fixtures from cue 2 are selected in the fixtures view and the values are active in the programmer (red values
with red background).
The tracked values from cue 1 are displayed in red.
Example 3
Let´s assume, you will edit the current active cue on the main executor.
Press Edit and then the large Go .
The fixtures from the current cue are selected and the values are active in the programmer (red values with red
background).
The tracked values are displayed in red.
If no cue on the main executor is active, cue 1 from the main executor will be loaded in the programmer.
Example 4
Let´s assume, you will edit a preset 1 of the position presets.
1. Open the position presets pool.
2. Press Edit and tap on preset 1 in the position presets pool.
The fixtures stored in preset 1 are selected in the fixtures view and the stored values are active in the
programmer.
Example 5
Let´s assume, you will edit a group 1 in the groups pool.
There are two ways to do this:
To Next Page
Loading...
