A chaser is an executor mode that runs in a loop, random or bounces in the cue list. Refer to, Settings of Executor
View or Cues View.
Cmd (Command):
Instructions you enter into the console.
Command Area:
The right area on the console, below screen 1, including all command keys and encoders.
Command Line:
Located on screen 1, to enter commands into the console. Refer to, How to use the Command Line or Command
Line.
Control:
Control attributes are, e.g. lamp control, fixture global and scan rate. Preset type number seven. Refer to, Control
Preset Type View.
Cue:
A look on stage. Refer to, What is a Cue, How to work with Cues or Cue View.
Cue List:
List with more than one cue, stored on an executor.
D
Dimmer Wheel:
The wheel rightmost on the console. It is always assigned to the dimmer attributes of the selected fixtures.
DMX (digital multiplex, DMX 512):
Communication protocol that connect light consoles with fixture types.
DMX address:
Is the start address which you have on the fixture and in console. Set the DMX address of a fixture in the console,
in the Select DMX Address Window.
DMX channel:
Each attribute of a fixture needs one (8bit) or two (16bit) DMX channels. 512 DMX channels are one DMX
universe. To see all channels of the eight available DMX universes, open the DMX view.
To Next Page
Loading...
