© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
Running the chaser
You can start the chaser by moving the fader from 0% and above 0%, this will run the chaser. You can also use a
Go or On command to run it in the direction you have set. If you use the GoBack command then the chaser runs,
but in the opposite direction. The Toggle command will toggle the current running status of the chaser. Off
command will stop the chaser. The Flash command will run the Chaser as long as you keep the key pressed.
You can assign all these commands to keys associated with the chaser or you can use them temporary by
pressing the function key on the dot2 and then one of the keys associated with the chaser.
To Next Page
Loading...
