Siemens SINUMERIK 828D - Page 104

Setting up the machine
3.11 Handwheel assignment
Turning
104 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
- OR
Open the "Axis" selection box using the <INSERT> key, navigate to the
desired axis, and press the <INPUT> key.
Selecting an axis also activates the handwheel (e.g., "X" is a
ssigned to
handwhee
l no. 1 and is activated immediately).
5.
Press the "Handwheel" softkey again.
- OR -
Press the "Back" softkey.
The "Handwheel" window closes.
Deactivate handwheel
1.
Positi
on the cursor on the handwheel whose assignment you wish to
cancel (e.g. No. 1).
2.
Press t
he softkey for the assigned axis again (e.g. "X").
- OR -
Open the "Axis" selection box using the <INSERT> key, navigate to the
empty field, and press the <INPUT> key.
Clearing an axi
s selection also clears the handwheel selection (e.g., "X"
is cleared for handwheel no. 1 and is no longer active).