Siemens SINUMERIK 828D - Equipping Multitool with Tools

Tool management
12.15 Working with multitool
Turning
724 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
12.15.3
Equipping multitool with tools
Precondition
A multitool has been created in the tool list.
Procedure
1.
The tool list is opened.
Equip the multitool with tools
2.
Select the required multitool, position the cursor on an empty
multitool location.
3.
Press the "New tool" softkey.
4.
Using the appropriate selection list, e.g. favorites, select the r
e-
quired tool.
Load multitool
2.
Select the required multitool, position the cursor on an empty
multitool location.
3.
Press the "Load" softkey.
The "Load with..." window opens.
4.
Select the required tool.
Load the tool into the multitool
2.
Position the cursor on the tool that you want to load into th
e multi-
tool.
3.
Press the "Load" and "Multitool" softkeys.
The "Load to..." window opens.
4.
Select t
he required multitool and the multitool location to which
you wish to load the tool.