Machining the workpiece
5.10 Editing a program
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
149
Note
The buffer memory contents are retained even afte
r the editor is closed, enabling you to
paste the contents in another program.
Note
Copy/cut current line
To copy and cut the current line where the cursor is positioned, it is not necessary to mark or
select it. You have the option of making the "Cut"
softkey only operable for marked program
sections via editor settings.
Opening additional programs (Page 152)
Editor settings (Page 153)
Keys of the operator panel (Page 27)
You can modify the block numbering of programs opened in the editor at a later point in time.
The program is opened in the editor.
A new vertical softkey bar appears.
Press the "Renumber" softkey.
The "Renumbering" window appears.
Enter the values for the first block number and the increment to be used
for numbering.
The program is renumbered.
If you only want to renumber a section, before the function call, select the program blocks
whose block numbering you want to edit.
When you enter a value of "0" for the increment size, then all of the existing block
numbers are deleted from the program and/or from the selected range.
To Next Page
Loading...
