Siemens SINUMERIK 828D - Calling Technology Cycles; Hiding Cycle Parameters; Setting Data for Cycles

Creating a G code program
7.9 Calling technology cycles
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
231
7.9
Calling technology cycles
7.9.1
Hiding cycle parameters
The documentation describes all the possible input parameters for each cycle. Depending on
the settings of the machine manufacturer, certain parameters can be hidden in the screens,
i.e. not displayed. These are then generated with the appropriate default values when the
cycles are called.
For additional information, please refer to the following references:
SINUMERIK Operate (IM9) / SINUMERIK 840D sl Commissioning Manual
Cycle support
Example
...
1.
Use the softkeys to select whether you want support for programming
contours, turning, drilling or milling cycles.
2.
Select the desired cycle using the softkey in the vertical softkey bar.
3.
Enter the parameters and p
ress the "Accept" softkey.
The cycle is transferred to the editor as G code.
7.9.2
Setting data for cycles
Cycle functions can be influenced and configured using machine and setting data.
For additional information, please refer to the following references:
Commissioning Manual SINUMERIK Operate / SINUMERIK 840D sl