Setting up the machine
3.9 Monitoring axis and spindle data
Turning
100 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
You store the chuck dimensions of the spindles at your machine in the "Spindle Chuck Data"
window.
Manually measuring a tool
If you want to use the chuck of the main or counter-spindle as a reference point during
manual measuring, specify the chuck dimension ZC.
Dimensions, main spindle jaw type 1
Dimensions, main spindle jaw type 2
You can measure either the forward edge or stop edge of the counter-spindle. The forward
edge or stop edge automatically serves as the valid reference point when traversing the
counter-spindle. This is especially important when gripping the workpiece using the counter-
spindle.
Dimensions, counter-spindle jaw type 1
Dimensions, counter-spindle jaw type 2
To Next Page
Loading...
