Siemens SINUMERIK 828D - Editing the Multi-Channel Program; Changing the Job List

Multi-channel machining
10.2 Multi-channel support
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
625
10.2.5
Editing the multi-channel program
10.2.5.1
Changing the job list
You now have the option to change the composition of the programs and/or the assignment
of the channel and program in a job list.
Precondition
● "programSYNC" option
Procedure
1.
Select the "Program Manager" operating area.
2.
Select whe
re the multi-channel program should be archived
3.
Position the cursor in the "Workpieces" folder on a job list and press the
"Open" softkey.
The window "Job list * JOB" is opened and the program assignment to
the channels is displayed.
4.
Select the channel to which you wish to assign a new program and
press the softkey "Select program".
The "Program" window is opened and displays all of the programs cr
e-
ated in the workpiece.
- OR -
Press the "Open job list" softkey.