Siemens SINUMERIK 828D - Selecting a Program

Machining the workpiece
5.2 Selecting a program
Turning
124 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Stopping machining
Press the <CYCLE STOP> key.
Machining stops immediately. Individual program blocks are not
executed to the end. On the next start, machining is resumed
from the point where it left off.
Canceling machining
Press the <RESET> key.
Execution of the program is interrupted. On the next start, machi
ning
will
start from the beginning.
Machine manufacturer
Please refer to the machine manufacturer's
specifications.
5.2
Selecting a program
Procedure
1.
Select the "Pr
ogram manager" operating area.
The directory overview is opened.
2.
Select the location where the program is archived (e.g. "NC")
3.
Place the cursor on the directory containing the program that you want
to select.
4.
Press the <INPUT> key
- OR -
Press the <Cursor right> key.
The directory contents are displayed.
5.
Place the cursor on the desired program.
6.
Press the "Select" softkey.
The program is selected.
When the program has been successfully selected, an automatic
changeover to the "Machine" operating area occurs.