Tool management
12.15 Working with multitool
Turning
730 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
You can position a magazine. In this case, a magazine location is positioned to the loading
point.
Multitools, which are located in a spindle, can also be positioned. The multitool is rotated and
therefore the multitool location involved is brought into the machining position.
The magazine list is opened.
The multitool is in the sp
indle.
Position the cursor on the multitool location that you want to bring
into the machining position.
Press the "Position multitool" softkey.
To Next Page
Loading...
