Managing programs
13.17 Setup data
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
779
When reading-in, you can select which of the backed-up data you wish to read-in:
● Tool data
● Magazine assignment
● Zero points
● Basic zero point
Depending on which data you have selected, the system behaves as follows:
● Complete tool list
First, all tool management data are deleted and then the saved data are imported.
● All tool data used in the program
If at least one of the tools to be read in already exists in the tool management system,
you can choose between the following options.
Select the "Replace all" softkey to import all tool data. Any existing tools
will
now be overwritten without a warning prompt.
Press the "Do not overwrite" softk
ey if existing tools must not be over-
Already existing tools are skipped, without you receiving any queries.
Press the "Skip" softkey if already existing tools are not to be overwri
t-
For an already existing tool, you receive a query.
For a magazine, if more than one loading point was set-up, using the "Select loading point"
softkey, you have the option of opening a window in which you can assign a loading point to
a magazine.
To Next Page
Loading...
Need help?
General
