Siemens SINUMERIK 828D - Operator Panel Fronts; Overview

Introduction
2.2 Operator panel fronts
Turning
26 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
2.2
Operator panel fronts
2.2.1
Overview
Introduction
The display (screen) and operation (e.g. hardkeys and softkeys) of the SINUMERIK Operate
user interface use the operator panel front.
In this example, the OP 010 operator panel front is used to illustrate the components that are
available for operating the controller and machine tool.
Operator controls and indicators
1 Alphabetic key group
With the <Shift> key pressed, you activate the special characters on keys with double assign-
ments, and write in the uppercase.
Note: Depending on the particular configuration of your control system, uppercase letters are
always written
2 Numerical key group
With the <Shift> key pressed, you activate the special characters on keys with double assign-
ments.
3
Control key group
4
Hotkey group
5
Cursor key group