Siemens SINUMERIK 828D - Entering Korean Characters

Introduction
2.4 User interface
Turning
60 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
2.4.13
Entering Korean characters
You can enter Korean characters in the input fields using the input editor IME (Input Method
Editor).
Note
You require a special keyboard to enter Korean characters. If this is not available, then you
can enter the characters using a matrix.
Korean keyboard
To enter Korean characters, you will need a keyboard with the keyboard assignment shown
below. In terms of key layout, this keyboard is the equivalent of an English QWERTY
keyboard and individual events must be grouped together to form syllables.
Structure of the editor
Functions
Editing characte
rs using a matrix
Editing characters using the keyboard
Entering Korean characters
Entering Latin letters
Precondition
The control has been switched over to Korean.