Siemens SINUMERIK 828D - Page 61

Introduction
2.4 User interface
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
61
Procedure
Editing characters using the keyboard
+
1.
Open the screen form and position the cursor on the input field.
Press the <Alt +S> keys.
The editor is displayed.
2.
Switch to the "Keyboard
- Matrix" selection box.
3.
Select the keyboard.
4.
Switch to the function selection box.
5.
Select Korean character input.
6.
Enter the required characters.
7.
Press the <input> key to enter the character into the input field.
Editing characters using a matrix
+
1.
Open the screen form and position the cursor on the input field.
Press the <Alt +S> keys.
The editor is displayed.
2.
Switch to the "Keyboard
- Matrix" selection box.
3.
Select the "matrix".
4.
Switch to the function selectio
n box.
5.
Select Korean character input.