Siemens SINUMERIK 828D - Calibrating the Touch Panel

HT 8
19.5 Calibrating the touch panel
Turning
856 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
19.5
Calibrating the touch panel
It is necessary to calibrate the touch panel upon first connection to the controller.
Note
Recalibration
If the operation is n
ot exact, then redo the calibration.
Procedure
1.
Press the back key and the <MENU SELECT> key at the same time to
start the TCU service screen.
2.
Touch the "Calibrate TouchPanel" button.
The calibration process will be started.
3.
Follow the instructions on the scr
een and touch the three calibration
points one after the other.
The calibration process has terminated.
4.
Touch the horizontal softkey "1" or the key with the number "1" to close
the TCU service screen.