Siemens SINUMERIK 828D - EditingExecuting a MDI Program

Setting up the machine
3.12 MDA
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
107
3.12.3
Editing/executing a MDI program
Procedure
1.
Select the "Machine" operating area.
2.
Press the <MDI> key.
The MDI editor opens.
3.
Enter the desired G-code commands using the operator’s keyboard.
- OR -
Enter a standard cycle, e.g. CYCLE62 ().
Editing G-code commands/program blocks
4.
Edit G-code commands directly in the "MDI" window.
- OR -
Select the required program block (e.g. CYCLE62) and press the <cu
r-
sor right> key, enter the required value and press "OK".
When editing a cycle, either the help screen or the graphic view can be
displayed.
5.
Press
the <CYCLE START> key.
The control executes the input blocks.
When executing G-code commands and standard cycles, you have the option of controlling
the sequence as follows:
● Executing the program block-by-block
● Testing the program
Settings under program control
● Setting the test-run feedrate
Settings under program control
See also
Program control (Page 139)