EasyManuals Logo

Siemens SINUMERIK 828D User Manual

Siemens SINUMERIK 828D
926 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #142 background imageLoading...
Page #142 background image
Machining the workpiece
5.9 Overstore
Turning
142 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
5.9
Overstore
With overstore, you have the option of executing technological parameters (for example,
auxiliary functions, axis feed, spindle speed, programmable instructions, etc.) before the
program is actually started. The program instructions act as if they are located in a normal
part program. These program instructions are, however, only valid for one program run. The
part program is not permanently changed. When next started, the program will be executed
as originally programmed.
After a block search, the machine can be brought into another state with overstore (e.g. M
function, tool, feed, speed, axis positions etc.), in which the normal part program can be
successfully continued.
Software option
You require the "Extended operator functions" option for the overstore function
(for 828D).
Precondition
The program to be corrected is in the Stop or Reset mode.
Procedure
1.
Open the program in the "AUTO" mode.
2.
Press the "Overstore" softkey.
The "Overstore" window opens.
3.
Enter the required data and NC block.
4.
Press the <CYCLE START> key.
The blocks you have entered are stored. You can observe exec
ution in
the "Overstore" window.
After the entered blocks have been executed, you can append blocks
again.
You cannot change the ope
rating mode while you are in overstore
mode.
5.
Press the "Back" softkey.
The "Overstore"
window closes.
6.
Press the <CYCLE START> key again.
The program selected before overstoring
continues to run.

Table of Contents

Other manuals for Siemens SINUMERIK 828D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 828D and is the answer not in the manual?

Siemens SINUMERIK 828D Specifications

General IconGeneral
Control TypeCNC
Operating SystemWindows Embedded
ProcessorIntel Atom
Display10.4" color TFT display
InterfacesEthernet, USB
ProgrammingShopMill, ShopTurn
Operation Panel Size10.4"
Protection ClassIP65
PLC Memory2 MB
Spindle Capacity4 spindles
Hard DriveCompactFlash

Related product manuals