Machining the workpiece
5.13 Mold making view
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
173
Starting the mold making view
Procedure
Select the "Program manager" operating area.
Select the desired storage location and position the cursor on the pr
o-
gram that you would like to display in the mold making view.
Press the "Open" softkey.
The program is opened in the
editor.
Press the ">>" and "Mold making view" softkeys.
The editor splits up into two areas.
The G code blocks are displayed in the left half of the editor.
The workpiece graphic is displayed in the right half of the editor.
All of the points and paths programmed
in the part program are shown
in the graphical representation.
Press softkey "Lines G1" or "Lines G0", to hide the corresponding line
elements of the graphic.
Press softkey "Hide points" to hide the points of the graphic.
:
You have the option of simultaneously hiding G1 and G0 lines.
In this case softkey "Hide points" is deactivated.
Press the "Graphic" softkey in order to hide the graphic and to view
the
program as usual in the editor
Press the "NC blocks" softkey in order to
hide the G code blocks and
therefore only to display the graphic.
To Next Page
Loading...
Need help?
General
