Siemens SINUMERIK 828D - Machine Control Panel Menu

HT 8
19.3 Machine control panel menu
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
853
19.3
Machine control panel menu
Here you select keys from the machine control panel which are reproduced by the software
by touch operation of the relevant softkeys.
See chapter "Controls on the machine control panel" for a description of the individual keys.
Note
PLC interface signals that are triggered via the softkeys of the machine control panel menus
are ed
ge triggered.
Showing and hiding
The user menu key "U" displays the CPF softkey bar (vertical softkey bar) and the user
softkey bar (horizontal softkey bar).
You can expand the user
softkey bar to display eight additional softkeys via
the menu forward key.
You use the
"Back" softkey to hide the menu bar again.