Siemens SINUMERIK 828D - Logging Measurement Results for the Workpiece Zero

Setting up the machine
3.6 Measuring the workpiece zero
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
87
3.6.2
Logging measurement results for the workpiece zero
When measuring the workpiece zero, you have the option to output the values that have
been determined to a log.
The following data are determined and logged:
● Date/time
● Log name with path
● Measuring version
● Input values
● Correction target
● Setpoints, measured values and differences
Note
Logging active
The measurement results can only be entered into a log once the measurement has been
fully completed.
Procedure
1.
You are in the "JOG" mode and have pressed the "Workpiece zero"
softkey.
The "Measurement log" softkey cannot be used.
2.
Select the required measurement version and measured the wor
kpiece
zero
as usual.
The measured values are displayed once the measurement has been
completed.
2.
Press the "Measurement log" softkey to save the measurement data as
log.
The "Measurement log" softkey becomes inactive again.