Easy Extend (828D only)
22.4 Initial commissioning of additional devices
Turning
880 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Initial commissioning of additional devices
Normally, the device has already been commissioned by the machine manufacturer. If an
initial commissioning has not been performed or if, for example, function tests are to be
performed again (e.g. when retrofitting additional devices), this is possible at any time.
The "Start-up" softkey has been declared as Manufacturer data class (M).
Select the "Parameter" operating area.
Press the menu forward key and then the "Easy Extend" softkey.
-up" softkey.
A new vertical softkey bar appears.
-up" softkey to start the commissioning.
Before starting, a complete data backup is generated which you can
then use in case of an emergency.
Press the "Cancel" softkey if yo
u want to abort the commissioning
Press the "Restore" softkey to load the
original data.
Press the "Device function test" softkey to test the machine manufa
c-
rer's intended function.
To Next Page
Loading...
Need help?
General
