Tool management
12.15 Working with multitool
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
727
Reactivating the multitool
Multitool and tools located on the multitool can be disabled independently of one another.
If a multitool is disabled, then the tools of the multitool can no longer be changed in using a
tool change.
If only one tool on a multitool has a set monitoring function and the lifetime or the unit
quantity has expired, then the tool and the multitool on which the tool is located are disabled.
The other tools on the multitool are not disabled.
Please refer to the machine manufactur
er's specifications.
If several tools with monitoring are mounted on the multitool and the lifetime or unit quantity
has expired for one tool, then only this tool is disabled.
If a tool with expired lifetime or unit quantity that is mounted on a multitool is reactivated,
then for this tool, the lifetime/unit quantity is set to the setpoint and the tool and the multitool
are re-enabled (disable status is removed).
If a multitool is reactivated, on which tools with monitoring are mounted, then the lifetime/unit
quantity for all tools on the multitool are set to the setpoint no matter whether the tools are
disabled or not.
In order to reactivate a tool, the monitoring function must be activated and a setpoint must be
stored.
To Next Page
Loading...
Need help?
General
