Siemens SINUMERIK 828D - Contour Call (CYCLE62) - Only for G Code Program

Programming technology functions (cycles)
9.3 Contour turning
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
403
9.3.7
Contour call (CYCLE62) - only for G code program
Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
The contour is in the calling main program.
2. Labels
The contour is in the calling main program and is limited by the labels that have been
entered.
3. Subprogram
The contour is located in a subprogram in the same workpiece.
4. Labels in the subprogram
The contour is in a subprogram and is limited by the labels that have been entered.
Procedure
1.
The part program to be executed has been created and you are in the
editor.
2.
Press the "Contour turning" softkey.
3.
Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
4.
Assign parameters to the contour selection.
Parameter
Description
Unit
Contour selection
• Contour name
• Labels
• Subprogram
• Labels in the subprogram
Contour name
CON: Contour name
Labels
• LAB1: Label 1
• LAB2: Label 2
Subprogram
PRG: Subprogram
Labels in the subpro-
gram
• PRG: Subprogram
• LAB1: Label 1
• LAB2: Label 2