Siemens SINUMERIK 828D - Editing the Dictionary

Introduction
2.4 User interface
Turning
58 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Editing characters using the Zhuyin method (only traditional Chinese)
+
1.
Open the screen form and positi
on the cursor on the input field.
Press the <Alt +S> keys.
The editor is displayed.
2.
Enter the desired phonetic notation using the numerical block.
Each number is assigned a certain number of letters that can be selec
t-
ed by pressing the numeric key one or several times.
3.
Press the <Cursor down> key to reach the dictionary.
4.
Keeping the
<Cursor down> key pressed, displays all the entered pho-
netic notations and the associated selection characters.
5.
Press the <BACKSPACE> softkey to delete entered phonetic notations.
6.
To select the associated character, press the <cursor right> or <cursor
left> keys.
7.
Press the <input> key to enter the character.
2.4.12.3
Editing the dictionary
Learning function of the input editor
Precondition:
The control has been switched over to Chinese.
An unknown phonetic notation has been entered into the input editor.
1.
The editor provides a further line in which the combined characters and
phonetic notations are displayed.
The f
irst part of the phonetic notation is displayed in the field for select-
ing the phonetic notation from the dictionary. Various characters are
listed for this particular phonetic notation.
2.
Press the number key to insert the associated character into the
addi-
tional line.
The next part of the phonetic notation is displayed in the field for selec
t-
ing the phonetic notation from the dictionary.
3.
Repeat step 2 until the complete phonetic notation has been compiled.