Siemens SINUMERIK 828D - Tool Selection for the Manual Mode

Working with a B axis (only 840D sl)
16.7 Tool selection for the manual mode
Turning
832 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
16.7
Tool selection for the manual mode
For the preparatory actions in the manual mode, tool selection and spindle control are both
performed centrally in the T, S, M window.
Figure 16-1 TSM window for the B and C axis
Procedure
Aligning the milling and turning tool with β angle
:
Press the <SELECT> key and select
•
0° or
•
90° or
•
Value entry box to freely enter the angle.
Aligning the turning tool with γ angle
:
Press the <SELECT> key and select
•
0°
•
180°
•
Value entry box to freely enter the angle.
See also
Selecting a tool and spindle (Page 109)