HT 8
19.2 Traversing keys
Turning
852 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
The traversing keys are not labeled. However, you can display a label for the keys in place of
the vertical softkey bar.
Labeling of the traversing keys is displayed for up to six axes on the touch panel by default.
Please refer to the machine manufacturer's specifications.
You can link the showing and hiding of the label to activation of the enabling button, for
example. In this case, the traversing keys are displayed when you press the enabling button.
If you release the enabling button, the traversing keys are hidden again.
Please refer to the machine manufacturer's specifications.
All existing vertical and horizontal softkeys are covered or hidden, i.e.
other softkeys cannot be used.
To Next Page
Loading...
