Siemens SINUMERIK 828D - Storing any New File

Managing programs
13.4 Creating a directory / program / job list / program list
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
745
3.
Press the "New" softkey.
4.
Press the "ShopTurn” softkey.
The "New S
tep Sequence Program" window opens.
The "ShopTurn" type is specified.
5.
Enter the desire
d program name and press the "OK" softkey.
The program name can contain up to 28 characters (name + dot + 3
-
character extension).
You can use all letters (with the exception of special characters, la
n-
guage
-specific special characters, Asian or Cyrillic characters), num-
bers and underscores (_).
13.4.5
Storing any new file
In each directory or subdirectory you can create a file in any format that you specify.
Note
File extensions
In the NC memory, the extension must have 3 characters, and DIR or WPD are not
permitted.
In the NC memory, you can create the following file types under a workpiece using the "Any"
softkey.