Working with Manual Machine
15.6 More complex machining
Turning
818 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Contour turning with Manual machine
For contour turning of simple geometric shapes, the same range of technological functions
(cycles) as in automatic mode is available.
Please refer to the machine manufacturer's spec
ifications.
The parameters of the input screen forms correspond to the parameters under Automatic
(see Section Contour turning (Page 390)).
If you have created a contour since the startup of the machine, the "Last co
n-
tour" softkey is available. You then have the option to reopen the input screen
with the last contour you entered in "Manual machine" for editing.
To Next Page
Loading...
