Siemens SINUMERIK 828D - Parameters for Block Search in the Search Pointer

Machining the workpiece
5.7 Starting machining at a specific point
Turning
136 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Note
Interruption point
You can load the interrupt
ion point in search pointer mode.
5.7.6
Parameters for block search in the search pointer
Parameter
Meaning
Number of program level
Program:
The name of the main program is automatically entered
Ext:
File extension
P: Pass counter
If a program section is performed several times, you can enter the number of
the pass here at which processing is to be continued
Line:
Is automatically filled for an interruption point
Type " " search target is ignored on this level
N no. Block number
Label Jump label
Text string
Subprg. Subprogram call
Line Line number
Search target
Point in the program at which machining is to start