Siemens SINUMERIK 828D - Display Active Zero Offset

Setting up the machine
3.8 Zero offsets
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
91
Note
Deselect fine offset (only 840D sl)
You have the option of deselecting the fine offset using machine data MD18600
$MN_MM_FRAME_FINE_TRANS
See also
Actual value window (Page 45)
3.8.1
Display active zero offset
The following zero offsets are displayed in the "Zero Offset - Active" window:
● Zero offsets, for which active offsets are included, or for which values are entered.
● Settable zero offsets
● Total zero offset
This window is generally used only for monitoring.
The availability of the offsets depends on the setting.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Procedure
1.
Select the "Parameter" operating area.
2.
Press the "Zero offset" softkey.
The "Zero Offset
- Active" window is opened.
Note
Further details on zero offsets
If you would like to see further details about the specified offsets or if you would like to
change values for the rotation, scaling or mirroring, press the "Details" softkey.