Siemens SINUMERIK 828D - Selecting a Magazine

Tool management
12.5 Tool list
Turning
690 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
12.5.7
Selecting a magazine
You can directly select the buffer memory, the magazine, or the NC memory.
Procedure
1.
The tool list is opened.
2.
Press the "Magazine selection" softkey.
If there is
only one magazine, you will move from one area to the next
(i.e. from the buffer memory to the magazine, from the magazine to the
NC memory, and from the NC memory back to the buffer memory) each
time you press the softkey. The cursor is positioned at the
beginning of
the magazine each time.
- OR -
If there is more than one magazine, the "M
agazine Selection" window
opens. Position the cursor on the desired magazine in this window and
press the "Go to ..." softkey.
The cursor jumps directly to the beginning of the specified magazine.
Hiding magazines
Deactivate the checkbox next to the magazines that you do not want to
appear in the magazine list.
The magazine selection behavior with multiple magazines can be configured in different
ways.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
References
For a description of configuration options, refer to the
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl