Siemens SINUMERIK 828D - Displaying the Zero Offset Overview

Setting up the machine
3.8 Zero offsets
Turning
92 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
3.8.2
Displaying the zero offset "overview"
The active offsets or system offsets are displayed for all axes that have been set up in the
"Work offset - overview" window.
In addition to the offset (course and fine), the rotation, scaling and mirroring defined using
this are also displayed.
This window is generally used only for monitoring.
Display of active work offsets
Work offsets
DRF
Displays the handwheel axis offset.
Rotary table reference Displays the additional work offsets programmed with $
P_PARTFRAME.
Basic reference
Displays the additional work offsets programmed with $P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
External WO frame
Displays the additional work offsets programmed with $P_EXTFRAME.
Total base WO
Displays all effective basis offsets.
G500 Displays the work offsets activated with G54 - G599.
Under certain circumstances, you can change the data using "Set
WO", i.e. you can correct a zero point that has been set.
Tool reference Displays the additional work offsets programmed with
$P_TOOLFRAME.
Workpiece reference
Displays the additional work offsets programmed with $P_WPFRAME.
Programmed WO
Displays the additional work offsets programmed with $P_PFRAME.
Cycle reference Displays the additional work offsets programmed with
$P_CYCFRAME.
Total WO Displays the active work offset, resulting from the total of all work off-
sets.
Procedure
1.
Select the "Parameter" operating area.
2
Press the "Work offset" and "Overview" softkeys.
The "Work offsets
- Overview" window opens.