Siemens SINUMERIK 828D - Programming

Creating a ShopTurn program
8.18 Example: Standard machining
Turning
274 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
8.18.2
Programming
1. Program header
1.
Specify the blank.
Measurement unit mm
Blank
Cylinder
XA
90
abs
ZA
+1.0
abs
ZI
-120
abs
ZB
-
100
abs
Retraction
simple
XRA
2
inc
ZRA
5
inc
Tool change point
Machine
XT
160
abs
ZT
409
abs
SC
1
S1
4000
rev/min
Machining direction
Climbing
2.
Press the "Accept" softkey.
The work plan is displayed. Program header and end of program are
created as program blocks.
The end of program is automatically defined.
2. Stock removal cycle for facing
1.
Press the "Turning" and "Stock removal" softkeys.
2.
Select the machining strategy.
3.
Enter the following technology parameters:
T
Roughing
tool_80
D1
F
0.300 mm/rev
V
350 m/min
4.
Enter the following parameters:
Machining
Roughing (∇)
Position
Direction
Face (parallel to the X axis)
X0
90
abs
Z0
2
abs