Siemens SINUMERIK 828D - Creating a New Contour

Programming technology functions (cycles)
9.3 Contour turning
Turning
392 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
The different colors of the symbols indicate their status:
Foreground
Background
Meaning
Black
Blue
Cursor on active element
Black Orange Cursor on current element
Black
White
Normal element
Red White Element not currently evaluated
(element will only be evaluated
when it is selected with the
cursor)
Graphic display
The progress of contour programming is shown in broken-line graphics while the contour
elements are being entered.
When the contour element has been created, it can be displayed in different line styles and
colors:
● Black: Programmed contour
● Orange: Current contour element
● Green dashed: Alternative element
● Blue dotted: Partially defined element
The scaling of the coordinate system is adjusted automatically to match the complete
contour.
The position of the coordinate system is displayed in the graphics window.
9.3.3
Creating a new contour
Function
For each contour that you want to cut, you must create a new contour.
The first step in creating a contour is to specify a starting point. Enter the contour element.
The contour processor then automatically defines the end of the contour.
Procedure
1.
The part program or ShopTurn program to be processed has been cr
e-
ated and you are in the editor.
2.
Press the "Contour turning" softkey.
3.
Press the "Contour" and "New contour" softkeys.
The "New Contour" input window opens.
4.
Enter a name for the new contour. The contour name must be unique.