Siemens SINUMERIK 828D - Page 230

Creating a G code program
7.8 Selection of the cycles via softkey
Turning
230 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
⇒
⇒
A menu tree with all of the available measuring versions of the measuring
cycle function "Measure workpiece" can be found in the following refe
r-
ence:
Programming Manual Measuring cycles / SINUMERIK 840D sl/828D
⇒
A menu tree with all of the available measuring versions of the measuring
cycle function "Measure tool" can be found in the follow
ing reference:
Programming Manual Measuring cycles / SINUMERIK 840D sl/828D
See also
General (Page 293)
Generating a G code program (Page 221)