Machining the workpiece
5.7 Starting machining at a specific point
Turning
132 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
You can start another search from the "Search target found" state. The cascading can be
continued any number of times after every search target found.
Note
Another cascaded block search can be started from the stopped program execution
only if
the search target has been found.
Function Manual Basic Functions; Block Search
● You have selected the desired program.
● The controller is in the reset state.
● The desired search mode is selected.
Pay attention to a collision-free start position and appropriate active tools and other
technological values.
If necessary, manually approach a collision-free start position. Select the target block
considering the selected block search type.
Toggling between search pointer and search positions
Press the "Search pointer" softkey again
to exit the "Search Pointer"
window and return to the "Program" window to define search positions.
Press the "Back" softkey.
You have now exited the block search function.
Selecting a program (Page 124)
To Next Page
Loading...
