Siemens SINUMERIK 828D User Manual

Machining the workpiece
5.10 Editing a program
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
151
Procedure
1.
Select the "Program manager" operating area.
2.
Select the storage location and create a program or open a program.
The program editor ope
ns.
3.
Select the required program blocks that you wish to combine to form a
block.
4.
Press the "Build block" softkey.
The "Build New Block" window opens.
5.
Enter a designatio
n for the block, assign the spindle, if required, select
the Addit. run
-in code and the automatic retraction and then press the
"OK" softkey.
Opening and closing blocks
6.
Press t
he ">>" and "View" softkeys.
7.
Press the "Open all blocks" softkey if you wish to displa
y the program
with all the blocks.
8.
Press the "Close all blocks" softkey, if you wish t
o display the program
again in a structured form.
Remove block
9.
Open the block.
10.
Position the cursor at the end of the block.
11.
Press the "Remove block" softkey.
Note
You can also open and close blocks using the mouse or the cursor keys:
•
<Cursor right> opens the block where the cursor is positioned
•
<Cursor left> closes the block if the cursor is positioned at the beginning or end of the
block
•
<ALT> and <Cursor left> closes the block if the cursor is positioned within the block

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English