Creating a ShopTurn program
8.4 Fundamentals
Turning
242 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
The turning machining plane corresponds to the X/Z plane (G18).
The Face/Face C machining plane corresponds to the X/Y plane (G17). For machines
without a Y axis, however, the tools can only move in the X/Z plane. The X/Y coordinates
that have been entered are automatically transformed into a movement in the X and C axis.
You can use face surface machining with a C axis for drilling and milling if, for instance, you
want to mill a pocket on the face surface. You can choose between the forward or rear face
surface for this purpose.
The Peripheral/Peripheral C machining plane corresponds to the Y/Z plane (G19). For
machines without a Y axis, however, the tools can only move in the Z/X plane. The Y/Z
coordinates that you entered are automatically transformed into a movement in the C and Z
axis.
You can use peripheral surface machining with a C axis for drilling and milling if, for instance,
you want to mill a slot with constant depth on the peripheral surface. You can choose
between the inner or outer surface for this purpose.
The face Y machining plane corresponds to the X/Y plane (G17). You can use the face
surface machining with a Y axis for drilling and milling if, for instance, you want to mill a
pocket on the face surface. You can choose between the forward or rear face surface for this
purpose.
The peripheral Y machining plane corresponds to the Y/Z plane (G19). You can use
peripheral surface machining with a Y axis for drilling and milling if, for instance, you want to
mill a pocket with a flat base on the peripheral surface or drill holes that do not point to the
center. You can choose between the inner or outer surface for this purpose.
To Next Page
Loading...
