Programming technology functions (cycles)
9.2 Rotate
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
357
Straight stock removal cycle with radii or chamfers.
The "Stock removal 2" input window opens.
Stock removal cycle with oblique lines, radii, or chamfers.
The "Stock Removal 3" input window opens.
G code program parameters
ShopTurn program parameters
S / V
Spindle speed or constant cut-
ting rate
rpm
m/min
Machining
• ∇ (roughing)
• ∇∇∇ (finishing)
Position
Machining position:
Machining
direction
Stock removal direction (transverse or longitudinal) in the coordinate system
Parallel to the Z axis (longitudinal)
Parallel to the X axis (transverse)
outside
inside
outside
Inside
X0 Reference point in X ∅ (abs, always diameter) mm
Reference point in Z (abs)
End point X (abs) or end point X in relation to X0 (inc)
End point Z (abs) or end point Z in relation to Z0 (inc)
Maximum depth infeed – (not for finishing)
To Next Page
Loading...
Need help?
General
