Siemens SINUMERIK 828D - Page 413

Programming technology functions (cycles)
9.3 Contour turning
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
413
Procedure
1.
The part program or ShopTurn program to be processed has been cr
e-
ated and you are in the editor.
2.
Press the "Contour turning" softkey.
3.
Press the "Stock removal resi
dual material" softkey.
The "Stock removal residual material" input window opens.
Parameters, G code program
Parameters, ShopTurn program
PRG
Name of the program to be generated
T
Tool name
PL Machining plane D Cutting edge number
RP
Retraction plane
mm
F
Feedrate
mm/rev
SC Safety clearance mm S / V
Spindle speed or constant cutting
rate
rpm
m/min
F
Feedrate
*
CON Name of the updated blank contour for
residual material machining (without the
attached character "_C" and double-
digit number)
Residual
material
With subsequent residual material re-
moval
• Yes
• No
CONR Name to save the updated unmachined-
part contour for residual material re-
moval - (only "Yes" for residual material
removal)
Parameters
Description
Unit
Machining
• ∇ (roughing)
• ∇∇∇ (finishing)
Machining
direction
• Face
• Longitudinal
•
Parallel to the contour
• From inside to outside
• From outside to inside
• From end face to rear side
• From rear side to end face
The machining direction depends on the stock removal direction and choice of tool.