Siemens SINUMERIK 828D - Page 437

Programming technology functions (cycles)
9.4 Milling
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
437
Figure 9-4 Geometries when chamfering inside contours
Note
The following error messages can occur when chamfering inside contours:
•
Safety clearance in the program header too large
This error message appears when chamfering would, in principle, be possible with the
parameters entered for FS and ZFS, but the safety clearance then could not be
maintained.
•
Immersion depth too large
This error message appears when chamfering would be possible through the
reduction of the immersion depth ZFS.
•
Tool diameter too large
This error message appears when the tool would already damage the edges during
insertion. In this case, the chamfer FS must be reduced.
Procedure
1.
The part program or ShopTurn program to be p
rocessed has been cre-
ated and you are in the editor.
2.
Press the "Milling" softkey.
3.
Press the "Pocket" and "Rectangular pocket" softkeys.
The "Rectangular Pocket" input window opens.